- White
or insignificantly tinted
- Mineral
- Environmentally
clean and safe
Composition
Plaster, fine fillers, modifying additives.
Recommended use
The putty is used for internal finishing to level non-deformable gypsum, concrete, lime, cement-lime and cement-sand surfaces (walls and ceilings) in dry premises prior to painting or paperhanging.
Surface preparation
- Prior
to application, remove unsteady sections from the base, widen cracks.
- Remove
dirt, dust, oil, paint, etc. from the surface.
- The
unsteady sections and highly absorbing surfaces should be first treated with
acrylic concentrate. It is
recommended to treat the surface with “SHEN” acrylic concentrate.
- The
surface should be cured for at least 4 hours, thereafter, the putty is applied.
Making the mixture
- Pour
580 – 680ml of water per 1kg of dry mixture into a clean container.
- Gradually
add dry mixture and stir with a mixer to obtain paste-like mass without lumps.
- Cure
the mixture for 5 minutes and mix again, and then the putty is ready for use.
Application
- Apply
the mixture with a stainless metallic putty trowel on the surface.
- The works should be done at the temperature no less than +10°C degrees.
- To
obtain smooth surface, polish the surface after drying of the putty.
- When
the work is over or suspended, carefully wash the tools.
- Dispose
of the paper bags and mixture leftovers as prescribed by local legislation.
- For
fast putty drying expose to air and moderate ventilation.
Temperature of the base when
applying
|
from +10°C to +30°C
|
Amount of water per 1kg of dry
mixture
|
580– 680ml
|
Amount of water per 10kg of dry
mixture
|
5,8-6,8l
|
Amount of water per 30kg of dry
mixture
|
17,4-20,4l
|
Recommended thickness of layer
|
up to 2mm
|
Time of serviceability of the
mixture
|
at least 1 hour
|
Shrinkage
|
not more than 0,6mm/m
|
Dry mixture consumption per 1cm
thick layer
More precisely, the consumption depends on the
surface quality and thickness of plaster layer.
|
0,9 -1,1 kg /1m²
|
10kg/ 9-11m²
|
30kg/27-33 m²
|
Sizes available
Paper and polypropylene bags. Net weight 10 and 30 kg.
Storage
Store in undamaged packaging, on palettes, in dry premises, at temperatures under 40°С and humidity under 75%, for 3 months after the manufacturing date indicated on the package.
Terms of use
- Store
in a place inaccessible to children.
- When
working, protect respiratory organs.
- Avoid
contact with skin.
- In
case of contact with eyes, rinse with clean water and, if needed, apply to
doctor.
Attention
- It
is prohibited to add water into the mixture after its tightening: this can
cause decreased mixture adhesion and cracking.
- When
working in conditions other than normal, the performances may deviate from the
ones indicated in the table.
- The
manufacturer bears no responsibility for working in violation of instructions.