F1 Facade Putty (White)
  • White
  • Mineral
  • Environmentally clean and safe
  • Weather resistant
Calcium carbonate, Portland cement, cellulose compounds, fillers, modifying additives.
Recommended use
The putty is used for interior and exterior finishing works (stone, brick, concrete, blocks, plaster), for filling cracks and holes.
Surface preparation
  • Prior to application, remove unsteady sections from the base, widen cracks
  • Remove dirt, dust, oil, paint, etc. from the surface.
  • The unsteady sections and highly absorbing surfaces should be first treated with acrylic concentrate. It is recommended to treat the surface with “SHEN” acrylic concentrate.
  • The surface should be cured for at least 4 hours, thereafter, the putty is applied.

Making the mixture

  • Pour 7,4–7,8l of water per 20kg of dry mixture into a clean container.
  • Gradually add dry mixture and stir with a mixer to obtain paste-like mass without lumps.
  • Cure the mixture for 10 minutes and mix again, and then the putty is ready for use.
  • Apply the mixture with a stainless metallic putty trowel on the surface.
  • Putty coating thickness should not exceed 1 mm. 
  • The works should be done at the temperature no less than +10°C degrees.
  • To obtain smooth surface, polish the surface after drying of the putty.
  • When the work is over or suspended, carefully wash the tools.
  • Dispose of the paper bags and mixture leftovers as prescribed by local legislation.

Temperature of the base when applying

from +10°C to +30°C

Amount of water per 1kg of dry mixture

370– 390ml

Amount of water per 20kg of dry mixture


Recommended thickness of layer

not less than 1mm

Time of serviceability of the mixture

3 hours


not more than 1mm/m


Dry mixture consumption per 1 cm thick layer

More precisely, the consumption depends on the surface quality and thickness of plaster layer.

1,2-1,6 kg/1m²  


Sizes available

Paper and polypropylene bags. Net weight 20 kg.

Store in undamaged packaging, on palettes, in dry premises, at temperatures under 40°С and humidity under 75%, for 6 months after the manufacturing date indicated on the package.
Terms of use
  • Store in a place inaccessible to children.
  • When working, protect respiratory organs.
  • Avoid contact with skin.
  • In case of contact with eyes, rinse with clean water and, if needed, apply to doctor.
  • It is prohibited to add water into the mixture after its tightening: this can cause decreased mixture adhesion and cracking.
  • When working in conditions other than normal, the performances may deviate from the ones indicated in the table.
  • The manufacturer bears no responsibility for working in violation of instructions.