Calculator:

М2 Plaster
  • Gray
  • Mineral
  • Environmentally clean and safe
  • High-strength
  • Weather resistant
Composition
Portland cement, sand, additives.
Recommended use
The putty is used for interior and exterior finishing works (stone, brick, concrete and blocks). It can also be used in the wall construction process.
Surface preparation
  • Prior to application, remove unsteady sections from the base, widen cracks.
  • Remove dirt, dust, oil, paint, etc. from the surface.
  • It is recommended to treat the surface with “SHEN” beton-contact.
  • Begin the work after 4-5 hours.

Making the mixture

  • Pour 4,75 – 5,25l of water per 25kg of dry mixture into a clean container.
  • Gradually add dry mixture and stir with a mixer to obtain paste-like mass without lumps.
Application
  • Apply the mixture with a stainless metallic putty trowel on the surface.
  • Putty coating thickness should be at least 1cm. 
  • The works should be done at the temperature no less than +10°C degrees.
  • When the work is over or suspended, carefully wash the tools.
  • Dispose of the paper bags and mixture leftovers as prescribed by local legislation.

 

Temperature of the base when applying

from +10°C to +30°C

Amount of water per 1kg of dry mixture

190 – 210ml

Amount of water per 25kg of dry mixture

4,75 – 5,25l

Recommended thickness of layer

not less than 1cm

Time of serviceability of the mixture

up to 30 minutes

Shrinkage

not more than 0.8 mm/m

 

Dry mixture consumption per 1cm thick layer

More precisely, the consumption depends on the surface quality and thickness of plaster layer.

1kg /0,06 m²

25 kg /1,5m²

Sizes available
Paper and polypropylene bags. Net weight 25kg.
Storage
Store in undamaged packaging, on palettes, in dry premises, at temperatures under 45°С and humidity under 75%, for 6 months after the manufacturing date indicated on the package.
Terms of use
  • Store in a place inaccessible to children.
  • When working, protect respiratory organs.
  • Avoid contact with skin.
  • In case of contact with eyes, rinse with clean water and, if needed, apply to doctor.
Attention
  • It is prohibited to add water into the mixture after its tightening: this can cause decreased mixture adhesion and cracking.
  • When working in conditions other than normal, the performances may deviate from the ones indicated in the table.
  • The manufacturer bears no responsibility for working in violation of instructions.